|
|
|
|
|
 |
|
|||
 |
|
#1
01-23-2010
|
||||
|
||||
|
blow down tube
Does this replace the burst disc or just attach to the blow off valve ?
Just emptied a full bottle due to a leaky burst disc (only leaked with valve open ???) weird.........But had some fun doing it 
__________________
11.8 @ 113 N.A. 
|
|
#2
01-24-2010
|
||||
|
||||
|
The blowdown tube only routes the nitrous away from the bottle (hopefully out of the cabin) after the burst disc opens up.
Be careful when you go to install the new disc, it must be torqued to spec. I don't know what the spec is so be sure to find that out before you install it...
__________________
95 Mustang GTS- 5 speed, 4.10's, long tubes, HCI, Chipped T4M0 running a modded L4C1 calibration, NOS Bigshot EFI Plate Kit (Cobra Intake), BMN window switch, MSD 6a, MSD timing retard, bottle heater, blah, blah, blah... New best: 8.0 through the 1/8 not sprayin in first. Usually around 87 mph every time. 60 ft's are droppin in to the low 1.7's...
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
