NX Iceman Confusion

[02 DC5]

http://i119.photobucket.com/albums/o147/jman2281/100_0176.jpg

http://i119.photobucket.com/albums/o147/jman2281/100_0175.jpg

The purge solenoid has 200hp written on both sides of the bottom where that red plug is currently. Im just a little confused to why both my n2o and purge have an In (from bottle), Out (to jets), and Purge Port. I guess this could possibly be for dual venting but i'm not going to do that. With a single vent is this the proper way to setup up the solenoids?

[02 DC5]

Someone has to know... Is this the right way to set it up?

feed line from bottle > In n2o solenoid (left)
line to jets > Out from n2o solenoid (at the bottom)
Connector to Purge solenoid > Purge Port of n2o solenoid (right)

Connector from n2o solenoid > In of Purge Solenoid (Left)
Bottom of purge solenoid is plugged (outlet, 200hp written on both sides)
Purge vent tube > Purge port of Purge solenoid (right)

[srsnow]

They probably have it that way so the solenoid could be either used as a side exit or a bottome exit. Just put an 1/p NPT plug in what ever side you don't use.

[02 DC5]

Yeah thats what I was thinking, basically just a smaller version of their n2o solenoid that they could use for either function, just wanted to make sure and see what others thought thanks.

[Nitrous4ME]

all you have there are two regular solenoids one larger than the other..not an actual purge solenoid...but thats fine just hook the little noid(purge solenoid) into the purge port on the larger one(nitrous solenoid that goes to intake) then put a plug in the puge side of the smaller noid, and the bottom exit which says to jets or w/e is where u hook in your purge line

[02 DC5]

So you think I should plug the purge port of the smaller one? Basically swap the purge tube with where that red plug is, I would think it wouldnt matter and just use either port to whichever is convenient.

[mrr23]

So you think I should plug the purge port of the smaller one? Basically swap the purge tube with where that red plug is, I would think it wouldnt matter and just use either port to whichever is convenient.

yes, you must plug the purge port of the smaller solenoid. if you don't when you open the bottle, it will just shoot right out. the way the NX solenoids work is side in, bottom out. so, both side ports go into the same chamber.

[Nitrous4ME]

yeah thats exactly right because the purge port basically just flows nitrous through without the solenoid having power that allows u to feed a purge solenoid