HSW Dry plate & NANO

[Munch]

I have a HSW sudden impact dry kit on order and want to use NANO with it. I'll be using the Interface controller as well as the microedge.

The info from NANO says to jet the N2O down 20-25% when using their system or tune for the added %. When I asked HSW about this they told me a jet will flow what it's set to flow and that's that. They also said they could see an increase in overall performance because of constant bottle pressure throughout the run but that was it.

So who's right and what should I do? I'm inclined to side with HSW on this as it makes sense but I'm new to N2O so I wanna be sure before I set everything up.

Thanks

[hammered54]

NANO??............did someone say .........NANO?

[MurdeЯ]

I would think NANO would be correct since they are the Mfg.

I also think HSW is misleading.... yes a jet will flow X amount, but change the pressure and the rate changes.

Start at lower jetting and tune from there ?