Purge question

[Solace87]

First off, sorry if this is a stupid question, I used the search function but didnt find anything.
Yesterday, I decided I wanted a dual purge on my car.
I looked them up and decided I could make one myself for ten bucks. So I used an old SuperPowershot solenoid and a 1/8 t fitting from the hardware store, and some air lines.

When I purge its invisible.
Do i need a special nozzle to make the 'cloud'?
here is a picture of the setup (sorry its terrible by the way)
http://i43.tinypic.com/13zpf0g.jpg

[BadgerType]

make sure your bottle is a good bottle

i had an old bottle and i couldnt make it produce any cloud whichever way the pickup line was. i bought a newer gen bottle and it produced a white cloud.

[Solace87]

This is the bottle I have
http://image.superstreetonline.com/f/12720583/130_0902_32_z+2008_mitsubishi_lancer_evolutionx+ni trous_express_bottle.jpg
I had it tested and they said it was good.
Now sorry if this is just the basics but if its at like 800psi would it still produce a cloud?
I dont have a heater because I barely drive the car and when I did in the past it was always warm enough that you wouldnt need a heater for just basic use.
I need to get one!

[hammered54]

it's not the bottle, it has a lot to do with the outside temp.
if it's warmer outside than what the bottle is it's going to be hard to see it.

[Solace87]

alright then that is probably it.
so I dont need any special nozzles then?

thank you for the help guys.

[mrr23]

no special nozzle. it has to do with outside temperature and humidity. the colder and wetter the air is, the more of a cloud you'll see.

[Solace87]

Ok thank you :), I'm gonna check your for sale section for a bottle warmer.